Image Areas | Options > Mask

• Related Articles

• Image Areas | Strategies for dealing with angled image areas

  Overview The purpose of this article is to recommend some approaches that can be used when a rotated or angled image area is required as part of a design on a product. But wait, isn't there already an article on this??? ...

• Masks | Understanding the Different Types of Masks for a 2D Product

  There are several types of masks that can be applied to a 2D Product within the platforms product configuration settings. Masks serve to either: control the product personalisation visually, affect the output that the system generates, or BOTH. All ...

• Print Areas | Masking > Print Masks

  Print masks need to match the Print dimensions which are set on the Print area to output correctly This information can be found on the Print area list view: Print Area list view showing the Print dimensions and DPI of the created Print Area. It can ...

• Print Areas | Print Area Regions

  Introduction Regions allow a specified portion of a print area to be cloned and re-applied elsewhere on the print area. They are often utilised to create mirroring or stretching effects. Important note: Regions are currently only supported in the ...

• Image Areas | Options > Fit Mode

  Please note that Fit Modes have been updated and as of 2022 there are 3 additional types which are detailed below - These types are Relative, Relative Contain and Tile. Top Tip: Watch on full screen for best quality / viewing experience! Please note ...